[. . . ] €¢ Do not pull the mains cable to disconnect the appliance. €¢ Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. €¢ Keep children and pets away from the appliance door when it is open. [. . . ] 2 Energy Saver This option decreases the temperature in the last rinse phase. The use of this option decreases the energy consumption (up to 25%) and the programme duration. €¢ If the option is not applicable to the programme, the related indicator flashes quickly 3 times and then goes off. 1 Multitab Activate this option only when you use the combi detergent tablets. If you stop to use the combi detergent tablets, before you start to use separately detergent, rinse aid and dishwasher salt, do these steps: 1. Make sure that the salt container and the rinse aid dispenser are full. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Manual adjustment Turn the water hardness dial to the position 1 or 2. Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. Press and hold, at the same time, butand button until the indicaton tors of programmes start to flash. €¢ The display shows the current setting of the water softener, e. Press the on/off button to deactivate the appliance and to confirm the setting. Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). Make sure that the appliance is in setting mode, refer to ’Setting and starting a programme’. €¢ If the rinse aid indicator is on, fill the rinse aid dispenser. €¢ If you use the combi detergent tablets, activate the Multitab option. Set and start the correct programme for the type of load and the degree of soil. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. 2 Setting and starting a programme Setting mode For some settings it is necessary that the appliance is in setting mode. [. . . ] Dishes are wet • The programme is without a drying phase or with a low temperature drying phase. €¢ The quality of the combi detergent tablets can be the cause. Try a different brand or activate the rinse aid dispenser and use rinse aid together with the combi detergent tablets. Press the on/off button to deactivate the appliance and to confirm the setting. [. . . ]